Screw Catheter Plug
A through hole screw shaped catheter - straight forward and plenty to enjoy despite the abbreviated length.
Master Series Triple Locking Stacker Ring
A full pound of stainless steel locked by a pin through three graduated rings makes this adornment a sight to behold. At an inch and a half wide with a dangling lock atop, this ring is certainly not intended for discretion.
While the rings are graduated in size (1.75, 1.875, and 2.0), the effective diameter is limited to the smallest rimg at 1.75. I suppose the individual rings could be worn, bit you have finer pieces in your collection for that purpose.
Big Balls Horseshoe
A large horseshoe with big balls to enhance your package, this one unfortunately falls short because of the size of the inner diameter. With a loose fit and a gapped bottom, this adornment is strictly for decoration rsther than enhancement.
Leather and Steel Double
A fun addition to the collection - this double stainless ring features leather straps to connect them at roughly 1" apart. The fact that the straps can be adjusted around the perimeter allows for some flexibility in the look as you wear this adornment.
Steel Trap Glans and Shaft
An interesting concept for sure, this glans or shaft ring features a set of stainless spikes surrounding the ring that allows one to tighten them into the shaft with a 1/8" hex key.
Unfortunately, the size is a bit awkward as it sits. Too large for a good glans ring that will stay put while flaccid and too small for a shaft ring while erect, this torturous adornment falls outside of the goldilocks range.
Hex Nut
If you’re looking for that industrial “bolted on” and locked in look, then this hex but ring is a worthy addition to the collection. Not as interesting or unique as the Gear Essentials Torque ring, it still stands out in the collection thanks to the polished stainless finish.
Generic Ball Weights
The classic stacker for your hangers. Pick up multiples in different sizes and weights to begin your collection.
Steel Wire Designer
Another custom creation from the workbench, this ring started as a standard banded ring with rubber inlays. Since I already had such a ring, I decided to remove the rubber and replace it with braided stainless steel wire. After cutting the wire to the exact length, it was secured in place with a mile adhesive and instant set plastic (Bondic).
As a ring that was already in the collection, this custom piece was made to fit a different niche with the larger inner diameter. This larger inner diameter is offset, of course, by the thick width of the ring itself.
Diablo
Kind of a gimmick more than anything else, but neat if the style suits you. The ring is fairly small and the protruding horns kind of ensure comfort isn’t to be grasped.
Classic Donut Small
This classic donut ring is a must have in any collection. With the smoothly radiused inner profile and nicely rounded outer profile leading into oval edges, comfort is practically guaranteed. Available in many sizes, my collection has one in several sizes to fit my mood.
The weight of the ring always reminds you that it is there and the thick width and wider height keeps pinching to a minimum even under tight jeans. Get one in several sizes!